Jake switch settings in Esa

[mp7]

(10-30-2024 )Rawze Wrote:  

(10-30-2024 )mp7 Wrote:  ...akes sense. I still have the old ecm and harness what else would have to be swapped if we went that direction? I thought the turbo and possibly egr ? Not using egr but not sure if it has to be installed.

Yes, when someone re-uses the old ecm and wiring harness from CM2350 to a CM2450 engine, the turbo off the older engine needs to be put on, and that is about it.

- it sounds to me like your far enough along at this point though to try to make what you got work like it is if you can.

ok thanks, the truck left for know so it will be a few weeks till I see it again