2350 to 2450 engine swap questions

[Rawze]

(05-09-2024 )5jranch Wrote:  Sorry for the confusion on my end. The cm2350 is already removed, it was hydro locked and couldn’t be started so I pulled it. I thought the engine I was installing was the same so I already have it installed. So how can I go about getting you the original file for the cm2350 that was one in the truck to begin with.

Insite software...
Save the ecm template out of the old ecm (Insite work order, and then make an ecm template from the ecm image) ...

(Insite or CT) ...
then flash it back to its factory programming according to its old engine ser# ...

(Insite) ...
and then restore the template + run the engine for 10 minutes.. even if it does have faults for the cans, etc.

== Then use CT software to copy out the clean file so that it can be e-mailed to me.