My Pete rebuild |
01-10-2020, (Subject: My Pete rebuild ) Post: #479 | |||
| |||
RE: My Pete rebuild Getting closer to something? ![]() Went through the IFSM and cleaned it out good, new gear fuel pump and transfer pump as PM. Gotta say, the new transfer pump sounds a lot nicer than the old one, even though it has a China sticker on it, and the old one was stamped USA... ![]() Adjustable idler had about .005" of wear on the bearing. Not sure if it could have had any measurable impact on the base timing? ![]() Remnants of a Sharpie Ninja ![]() New actuator is a LOT quieter than the old one. Not sure if it's normal, but the the compressor housing on the Cummins turbo was not even close to being clocked correctly? ![]() | |||
|
« Next Oldest | Next Newest » |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.